From: Jim Brown (Jim.Brown@xxxxxxxxxxxxx)
Date: Thu Feb 08 2001 - 12:35:56 GMT-3
Tariq,
On a 2600 the dnld command allows you to use and Ethernet interface to tftp
download an image. You use the set commands to specify interface parameters
and gateway.
There was a document on CCO about "disaster recovery". I'm assuming this
might also apply to the 3600.
-----Original Message-----
From: Tariq Sharif [mailto:tariq_sharif@btinternet.com]
Sent: Thursday, February 08, 2001 8:22 AM
To: Ccielab@Groupstudy. Com
Subject: 3620 Boot Problem
Managed to wipe 3620 flash. Now it goes into ROMMON at bootup. Can't see any
commands to download IOS from TFTP server. The closet is xmodem. Here is the
list:
rommon 4 > ?
alias set and display aliases command
boot boot up an external process
break set/show/clear the breakpoint
confreg configuration register utility
cont continue executing a downloaded image
context display the context of a loaded image
cookie display contents of cookie PROM in hex
dev list the device table
dir list files in file system
dis disassemble instruction stream
dnld serial download a program module
frame print out a selected stack frame
help monitor builtin command help
history monitor command history
meminfo main memory information
repeat repeat a monitor command
reset system reset
set display the monitor variables
stack produce a stack trace
sync write monitor environment to NVRAM
sysret print out info from last system return
unalias unset an alias
unset unset a monitor variable
xmodem x/ymodem image download
rommon 5 >
Tried Router Software Loader but no luck. Any ideas?
Many thanks & regards.
Tariq Sharif
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:28:41 GMT-3