From: Michael E. Flannagan (mflannag@xxxxxxxxx)
Date: Wed Feb 07 2001 - 20:37:21 GMT-3
I read that as:
Other EIGRP routers should have no clue that there is a token-ring0
interface. That would require a distribute list, because
passive-interface just keeps you from sending updates on that
interface...it doesn't keep you from advertising that interface if it's
included in the network statement.
------------------------------------------------------------
C i s c o S y s t e m s Michael E. Flannagan
| | Network Consulting Engineer
||| ||| Research Triangle Park, NC
||||||| ||||||| (919) 392-4550
.:|||||||||||:.:|||||||||||:. mflannag@cisco.com
------------------------------------------------------------
On Thu, 8 Feb 2001, Simon Baxter wrote:
> Can anyone clarify the requirements when a question is worded :
>
> "Configure eigrp on the serial link between R1 and R2. Make sure
> token-ring0 is not included in eigrp"
>
> If the serial link network address falls in the same class boundary as the
> token, the token network will still advertised even if there's an
> appropriate passive-interface.
>
>
> Is the question asking you not to send eigrp updates down the link?
>
> Or is is asking you to do a distribute-list out (or similar) to exclude the
> token ring network???
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:28:41 GMT-3