From: Larry Roberts (lroberts22@xxxxxxxxxx)
Date: Mon Feb 05 2001 - 22:49:45 GMT-3
Do you know how much RAM you have in it? There is a jumper setting that you
set depending on how much RAM you have. It looks like that setting could be
incorrect. Check out the following link for more information on determining
how much RAM you have and how to set the jumper correctly.
http://www.cisco.com/univercd/cc/td/doc/product/access/acs_serv/cis500cs/500
cshim/22278.htm
Hope this helps,
Larry Roberts
----- Original Message -----
From: David C Prall <dcp@dcptech.com>
To: CCIE Lab groupstudy.com <ccielab@groupstudy.com>
Sent: Monday, February 05, 2001 8:38 AM
Subject: Re: Communication Server - CS-500 problem
> ----- Original Message -----
> From: "Tariq Sharif" <tariq_sharif@btinternet.com>
> > Any ideas on why a CS-500 would not boot properly. The OK light keeps
> > flashing after booting. I can bypass config by holding down Default key
> > while powering it. I suspect that confreg is incorrect, but can't see
any
> > commands to set (I assume the value should be 0x102). Model is CS 516
with
> > IOS 9.2.
> >
> > Many thanks & regards.
> >
> > Tariq Sharif
> >
> The config-register on mine is 0x101 and has been running without any
> problems.
>
> David C Prall dcp@dcptech.com http://dcp.dcptech.com
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:28:37 GMT-3