From: Allyn Baskerville (abaskerville@xxxxxxxxx)
Date: Wed Jan 31 2001 - 14:35:18 GMT-3
>From the Doc CD:
The following example shows how to configure the internal cross-connect PVC
on Switch B between interface 3/0/1, VPI = 0, VCI = 50, and interface 3/0/2,
VPI = 2, VCI = 100 (see Figure 5-1):
Switch-B(config)# interface atm 3/0/1
Switch-B(config-if)# atm pvc 0 50 interface atm 3/0/2 2 100
The following example shows how to configure the internal cross-connect PVC
on Switch C between interface 0/0/0, VPI = 2, VCI = 100, and interface
0/0/1, VPI 50, VCI = 255:
Switch-C(config)# interface atm 0/0/0
Switch-C(config-if)# atm pvc 2 100 interface atm 0/0/1 50 255
Each subsequent VC cross-connection and link must be configured until the VC
is terminated to create the entire VCC.
-----Original Message-----
From: Vikas Gupta [mailto:vicky_gupta1803@yahoo.com]
Sent: Wednesday, January 31, 2001 11:22 AM
To: ccielab@groupstudy.com
Subject: building PVCs on LS1010
Hi Group,
Can somebody post the sample config of building PVCs
on LS1010 like you would do on a frame switch.
Thanks!
Vikas
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:27:50 GMT-3