From: David M Anderson (dma@xxxxxxxxx)
Date: Wed Jan 24 2001 - 14:00:02 GMT-3
I would start from the beginning. Make sure your keepalives match, use the deb
ugs Chuch suggested. Also make sure you know the inherent problems with the sa
me DLCI being configured under a map statement that was also learned through in
verse arp.
At 11:21 AM 01/24/2001 -0500, Mask Of Zorro wrote:
>Always troublshoot Frame Relay from BOTH SIDES...
>
>Z
>
>
> >From: "Chuck Larrieu" <chuck@cl.cncdsl.com>
> >Reply-To: "Chuck Larrieu" <chuck@cl.cncdsl.com>
> >To: "Ifeanyi Eze" <ieze@callisma.com>, <ccielab@groupstudy.com>
> >Subject: RE: Problem configuring a hub and spoke frame switch in 2520
> >series
> >Date: Wed, 24 Jan 2001 07:49:00 -0800
> >
> >What do your debug frame lmi, debug frame packet and debug frame event
> >outputs tell you?
> >
> >The configurations from the router in question would help, also.
> >
> >-----Original Message-----
> >From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
> >Ifeanyi Eze
> >Sent: Tuesday, January 23, 2001 7:34 AM
> >To: ccielab@groupstudy.com
> >Subject: Problem configuring a hub and spoke frame switch in 2520 seri
es
> >
> >Help please
> >
> >
> >
> >Below is the config for the frame switch
> >interface serial 0
> >no ip address
> >encapsulation frame-relay
> >frame-relay intf-type dce
> >clockrate 64000
> >keepalive 15
> >frame-relay route 100 interface serial 2 201
> >!
> >interface serial 1
> >no ip address
> >encapsulation frame-relay
> >frame-relay intf-type dce
> >clockrate 64000
> >keepalive 15
> >frame-relay route 101 interface serial 2 102
> >!
> >interface serial 2
> >encapsulation frame-relay
> >frame-relay intf-type dce
> >clockrate 64000
> >keepalive 15
> >frame-relay route 201 interface serial 0 100
> >frame-relay route 102 interface serial 1 101
> >
> >Spicey and Aton works fine through inverse-arp. Prasit s1 maintains up/up
> >status but with frame-relay dte, lmi, and pvc down. I have swapped cables,
> >interfaces and router to no avail. When I add keepalive 15 on Prasit s1,
> >it
> >goes down.
> >Any help will be appreciated.
> >
> >Eze
> >
> >
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:27:42 GMT-3