From: Justin Menga (Justin.Menga@xxxxxxxxxxxxxxxxxx)
Date: Tue Jan 23 2001 - 23:47:09 GMT-3
Should work, it is very simple:
1. Dial peer must request RSVP using 'req-qos ....' command
2. Each interface (ingress and egress) to the session target MUST request
RSVP using 'ip rsvp bandwidth x x' command
Regards,
Justin Menga CCIE #6640 MCSE+I CCSE
WAN Specialist
Computerland New Zealand
PO Box 3631, Auckland
DDI: (+64) 9 360 4864 Mobile: (+64) 25 349 599
mailto: justin.menga@computerland.co.nz
-----Original Message-----
From: Brian Hescock [mailto:bhescock@cisco.com]
Sent: Wednesday, 24 January 2001 3:21 p.m.
To: ccielab@groupstudy.com
Subject: problems with RSVP for VOIP
Have any of you tried RSVP with VOIP as shown in the sample config at
the following url:
http://www.cisco.com/univercd/cc/td/doc/product/software/ios120/12cgcr/voice
_c/vcprt1/vcvoip.htm
I can't seem to get it to work (no reservations). I noticed the sample
config was missing "ip rsvp sender" and "ip rsvp reserv" but it still
didn't work after adding those commands also. Any ideas? My config is
identical to the example.
Brian
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:27:41 GMT-3