From: Patrick Bikar (pbikar@xxxxxxxxx)
Date: Thu Jan 11 2001 - 16:53:35 GMT-3
Justin,
Thanks for the clear answer.
Does it acctually mean that configuring SVCs on an LS1010 is simpler than
configuring PVCs ?
Don't you need to specify the atm-nsap prefix of the switch ?
Do you know what is configured by default (ilmi, qsaal, ...) ?
Thanks for any hints !
Patrick.
At 22:09 11/01/2001 +1300, Justin Menga wrote:
>Hi,
>
>All you need to do is start with a default configuration, 'no shut' on the
>ATM access ports. You can do SVCs now.
>
>Then to add a PVC, on either of the PVC interfaces (not both as you do for
>frame relay) configure:
>
>int atm1/0/0
> desc Connected to R1
> atm pvc 0 100 int atm1/0/1 0 200
>
>int atm1/0/1
> desc COnnected to R2
>
>R1 ---------- LS1010 --------- R2
> (0/100) (0/200)
>
>
>Regards,
>
>Justin Menga CCIE #6640 MCSE+I CCSE
>WAN Specialist
>Computerland New Zealand
>PO Box 3631, Auckland
>DDI: (+64) 9 360 4864 Mobile: (+64) 25 349 599
>mailto: justin.menga@computerland.co.nz
>
>
>
>-----Original Message-----
>From: Patrick Bikar [mailto:pbikar@cisco.com]
>Sent: Thursday, January 11, 2001 9:36 PM
>To: ccielab@groupstudy.com
>Subject: Simple LS1010 config
>
>
>Hi all !
>
>Could anyone send me a simple LS1010 config in order to be able to set up
>PVCs and SVCs between 2 routers with atm interfaces ? The configs of the
>routers are welcome also if possible.
>
>Thanks !
>Patrick.
>
>
>Patrick.
>CCNP, Belgium.
>Lab:15/03/2001
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:27:27 GMT-3