From: kaushik (kaushik@xxxxxxxxx)
Date: Wed Jan 10 2001 - 00:06:12 GMT-3
sorry for the late reply..
But are you using 'enterprise' code on both ends? Otherwise this will not work.
thanks
kaushik roy
-----Original Message-----
From: RAMIL>:-p [SMTP:ramil@skibuff.com]
Sent: Sunday, December 17, 2000 6:09 PM
To: ccielab@groupstudy.com
Subject: Using Two 2500 Routers as Frame Switch
I tried making a frame switching using two 2500 routers connect via AUX =
ports. I put IP addresses on the async interface, used PPP =
encapsulation and CHAP authentication. I set the transmit and receive =
speed on the AUX port to 38,400. I created a tunnel interface to go =
from the local async interface to the remote router and vice versa. I =
then continued with the regular config for a frame switch. Enabling =
"frame switching", specifying the "intf-type dce", using the "frame =
route" command but attempted to use the Tunnel interface instead of the =
Serial interface as per instructions in Rudenko's "Little Black Book". =
Doesn't work. I can't put the tunnel interface in, in place of the =
serial interface. What gives? I'm running 12.0 code and I'm using the =
rollover console cable between boxes. I have no idea why DLCI 421 and =
423 are being used either. Here is the config from Rudenko's "Little =
Black Book":
R2
(s0) dlci 201 to R1, dlci 203 to R3
|
(s0)
FR2
(a1)
/
(a1)=20
FR1
dlci 102 to R2 (s0) (s1) dlci 302 to R2
| \
(s0) (s0)
R1 R3
FR1
username FR2 password 0 cisco
frame-relay switching
interface tunnel0
tunnel source 1.0.0.1
tunnel destination 1.0.0.2
interface serial0
encapsulation frame-relay
frame-relay intf-type dce
clockrate 2000000
frame-relay route 102 interface tunnel 0 421 <--- can't config
interface serial1
encapsulation frame-relay
frame intf-type dce
clockrate 2000000
frame route 302 interface tunnel 0 423 <--- ditto
interface async 1
ip address 1.0.0.1 255.255.255.0
encaps ppp
async mode dedicated
async default routing
ppp authentication chap
lin aux 0
rxspeed 38400
txspeed 38400
=20
FR2
username FR1 password 0 cisco
frame-relay switching
interface tunnel0
tunnel source 1.0.0.2
tunnel destination 1.0.0.1
interface serial0
encapsulation frame-relay
frame-relay intf-type dce
clockrate 2000000
frame-relay route 201 interface tunnel 0 421 <--- can't config
frame-relay route 203 interface tunnel 0 423 <--- ditto
=20
interface async 1
ip address 1.0.0.2 255.255.255.0
encaps ppp
async mode dedicated
async default routing
ppp authentication chap
lin aux 0
rxspeed 38400
txspeed 38400
Thanks,
RAMIL>:-p
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:27:25 GMT-3