From: Casassa, Nathan (ncasassa@xxxxxxxxxxx)
Date: Sat Jan 06 2001 - 17:00:35 GMT-3
You can take 2 routers that have two serial ports and create a tunnel
between them to create a frame-switch. I am sure this link has been posted a
dozen times, but here is a good papers to get some ideas if your just
beginning. Check out the CCIE home lab guide:
http://www.ccprep.com/resources/Whitepapers.asp
N
-----Original Message-----
From: Gene Park [mailto:gpark_56@yahoo.com]
Sent: Saturday, January 06, 2001 12:35 PM
To: ccielab@groupstudy.com
Subject: help for lab setup!
Dear Members:
I've given following hardware to set up CCIE lab for a group of people. So
I'm looking for tips
for topology. Any ideas would be appreciated. And I have some questions.
1. With the routers provided, I don't think I can make frame relay
switch. My guess is that I have
to insert 4-port serial network module in an available slot on 3600. Am I
right or any other
suggestions?
2. In ATM module, what do I have to plug into ATM0? Is it an ATM switch
or some other gear to have
practices? I'm not sure on this. I heard that ATM LANE is no longer tested
in the lab.
3. For the voice, 2 channel voice module is installed. I think two
phones are required. What else
do I need? I never had practice on the VOIP. Please help.
2 of 2503
2 of 2513
4 of 2514
1 of 2509
2 of 3600(3 modules in there)
2-channel voice network(voice 2v)
ATM IA-OC3MM
FastEthernet 1 FE-TX
1 of 2900XL Cat
1 of MAU
Thank you for your help.
Gene
gpark_56@yahoo.com
=====
Gene Park
gpark_56@yahoo.com
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:27:23 GMT-3