From: Kevin Baumgartner (kbaumgar@xxxxxxxxx)
Date: Tue Jan 02 2001 - 18:49:00 GMT-3
So this is a CCIE study group right? How does learning about Juniper equipment
help to that goal? Let get back to studying on Cisco routers.
Kevin
At 03:39 PM 1/2/01 -0500, Casassa, Nathan wrote:
>The class is still based on standard internetworking concepts and protocols.
>You will configure OSPF, IS-IS, BGP, and MPLS. If you have been doing this
>in a Cisco environment, it will help you greatly. You will learn Junipers
>implementation of these protocols, and their vendor specific tweaks and
>configuration methods. The JUNOS architecture differs greatly and in my
>opinion is much better. I better get myself off of this Juniper tangent
>before I get flooded and recommend taking these posts over to Puck's Juniper
>list. It is not very active, but will pick up as they get bigger.
>
>http://puck.nether.net/lists/
>
>-----Original Message-----
>From: Roderick Ta [mailto:rta@nortelnetworks.com]
>Sent: Tuesday, January 02, 2001 3:18 PM
>To: zheng jiang gu; ccielab@groupstudy.com
>Subject: RE:
>
>
>If you will have to configure Juniper routers, then it is
>a very good starting point. Juniper routers have different
>architecture and configuration than Cisco's.
>
>I was told by some that configurations are the same, but
>the class showed without prior training or practicing in
>the lab, you cannot just sit in front of a Juniper router
>and use your Cisco knowledge to complete the tasks.
>
>Roderick Ta
>
>
>-----Original Message-----
>From: zheng jiang gu [mailto:zjgu@ce-air.com]
>Sent: Thursday, December 28, 2000 10:21 PM
>To: ccielab@groupstudy.com
>Subject:
>
>
>Hi :
> Did anyone attend the training of
>"http://www.juniper.net/support/training "?
>Do you think it worthy for 2500$
>zjgu
>
>
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:27:21 GMT-3