From: Casassa, Nathan (ncasassa@xxxxxxxxxxx)
Date: Tue Jan 02 2001 - 17:39:29 GMT-3
The class is still based on standard internetworking concepts and protocols.
You will configure OSPF, IS-IS, BGP, and MPLS. If you have been doing this
in a Cisco environment, it will help you greatly. You will learn Junipers
implementation of these protocols, and their vendor specific tweaks and
configuration methods. The JUNOS architecture differs greatly and in my
opinion is much better. I better get myself off of this Juniper tangent
before I get flooded and recommend taking these posts over to Puck's Juniper
list. It is not very active, but will pick up as they get bigger.
-----Original Message-----
From: Roderick Ta [mailto:rta@nortelnetworks.com]
Sent: Tuesday, January 02, 2001 3:18 PM
To: zheng jiang gu; ccielab@groupstudy.com
Subject: RE:
If you will have to configure Juniper routers, then it is
a very good starting point. Juniper routers have different
architecture and configuration than Cisco's.
I was told by some that configurations are the same, but
the class showed without prior training or practicing in
the lab, you cannot just sit in front of a Juniper router
and use your Cisco knowledge to complete the tasks.
Roderick Ta
-----Original Message-----
From: zheng jiang gu [mailto:zjgu@ce-air.com]
Sent: Thursday, December 28, 2000 10:21 PM
To: ccielab@groupstudy.com
Subject:
Hi :
Did anyone attend the training of
"http://www.juniper.net/support/training "?
Do you think it worthy for 2500$
zjgu
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:27:21 GMT-3