From: Tim Lewin (tlewin@xxxxxxxxxxxxxxxxxxx)
Date: Thu Dec 28 2000 - 19:28:43 GMT-3
Try adding
Bridge 1 protocol IEEE
bridge 1 route IP (enable BVI to accept & route IP from Bridge
Group)
The W/S default G/W should be the BVI address.
regards...Tim
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Lye Beng, Ong
Sent: Friday, 29 December 2000 8:11 AM
To: ccielab@groupstudy.com
Subject: (Q) IRB problem
Hi all,
I am trying to configure IRB. I have a NT workstation connected to the
bridge interface (e2/2). The workstation ip address is 12.0.0.5/8.
When I try to ping from the router to the w/s I got the following
error (deb arp). I can see that the icmp packet reach the w/s and the
w/s tries to arp for the ip address 12.0.0.1, but it never got any
reply.
What should be the w/s default gateway setting ?
Plese help. Thanks.
Regards,
-- LB
3w0d: IP ARP: creating incomplete entry for IP address: 12.0.0.5 interface
BVI1
3w0d: IP ARP: sent req src 12.0.0.1 0030.94a3.aea2,
dst 12.0.0.5 0000.0000.0000 BVI1
3w0d: IP ARP rep filtered src 12.0.0.5 00c0.4f60.3d20, dst 12.0.0.1
0030.94a3.aea2 wrong cable, interface Ethernet2/2.
3w0d: IP ARP: sent req src 12.0.0.1 0030.94a3.aea2,
dst 12.0.0.5 0000.0000.0000 BVI1
below is my partial configuration. I am running 12.0(7)T.
bridge irb
interface Ethernet2/0
ip address 10.0.0.1 255.0.0.0
no ip directed-broadcast
no keepalive
!
interface Ethernet2/1
ip address 11.0.0.1 255.0.0.0
no ip directed-broadcast
no keepalive
!
interface Ethernet2/2
no ip address
ip directed-broadcast
no ip route-cache
no ip mroute-cache
bridge-group 1
interface BVI1
ip address 12.0.0.1 255.0.0.0
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:26:12 GMT-3