From: Gordon Olson (golson@xxxxxxx)
Date: Sun Dec 17 2000 - 20:54:34 GMT-3
That was the first thing I tried. I can do a no keepalive on the e0 and then
I can ping it. The interface is up right now because of the "no keepalive"
command. Look at the packets output and bytes, how is this incrementing?
Anyone have any ideas on how to bring up this interface? I have searched the
Documentation cd and cannot realy find anything that addresses it. If I put
the keepalives back the interface goes down and I am not able to ping itself
or anything else on the network.
sh int e0
Ethernet0 is up, line protocol is up
Hardware is Lance, address is 0010.7b68.5039 (bia 0010.7b68.5039)
Internet address is 192.168.1.2 255.255.255.0
MTU 1500 bytes, BW 10000 Kbit, DLY 1000 usec, rely 128/255, load 1/255
Encapsulation ARPA, loopback not set, keepalive not set
ARP type: ARPA, ARP Timeout 4:00:00
Last input 0:01:39, output 0:00:57, output hang never
Last clearing of "show interface" counters never
Output queue 0/40, 0 drops; input queue 0/75, 0 drops
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
0 input packets with dribble condition detected
225 packets output, 15079 bytes, 0 underruns
225 output errors, 0 collisions, 3 interface resets, 0 restarts
0 output buffer failures, 0 output buffers swapped out
-----Original Message-----
From: G F Marsh [mailto:gfm@tesco.net]
Sent: Sunday, December 17, 2000 1:48 PM
To: Gordon Olson; ccielab@groupstudy.com
Subject: Re: Cat3100 with integrated 2503
Check your cable, is it a crossover or a straight through?
Gary
----- Original Message -----
From: Gordon Olson <golson@psn.net>
To: <ccielab@groupstudy.com>
Sent: Saturday, December 16, 2000 11:08 PM
Subject: Cat3100 with integrated 2503
> I have a Cat 3100 switch with a 2503 integrated into it. I have another
> router 2501 connected via serial port - crossover cable configured for
> frame-relay and that appears to be working fine, passing LMI. Both
> interfaces are up.
>
> But I cannot bring up the Ethernet interface on the 2503. I am not sure
how.
> I have a transceiver connected to the AUI and a cat 5 cable ran to a hub,
I
> have another cable hooked directly to my PC from the hub.
> I verified that there was not a cable or hub problem because I can bring
up
> the e0 int on a different router. But I think because the AUI is actually
on
> the switch and not on the Integrated 2503 is where the problem is.
>
> I configured the 3100 with an Ip address but it still does not work. I
canot
> even ping it from within the switch or within the 2503.
>
> Anyone have a clue for me?
>
>
>
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:26:03 GMT-3