access-expression

From: zhangxianqi (zhangxqi@xxxxxxxxxxx)
Date: Fri Dec 15 2000 - 05:01:08 GMT-3

• Next message: Bill.E.Riddiford@xxxxxx: "Lab Belgium"
• Previous message: china1124: "multicast again"
• Next in thread: SherefMohamed@xxxxxxx: "Re: access-expression"
• Maybe reply: SherefMohamed@xxxxxxx: "Re: access-expression"
• Maybe reply: zhangxianqi: "Re: access-expression"
• Maybe reply: Fred Ingham: "Re: access-expression"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

   
hi,
Can access-expression be used in ethernet interface,I want to test it,but when
I config the access-expression as below
access-list 200 deny 0xf0f0 0101
int e 0
access-expression in lsap(200)

I want to see no netbios taffic enter my router,but....,the netbios traffic get
 through,it looks the access-expression not take effect,why?

Regards
xianqi

• Next message: Bill.E.Riddiford@xxxxxx: "Lab Belgium"
• Previous message: china1124: "multicast again"
• Next in thread: SherefMohamed@xxxxxxx: "Re: access-expression"
• Maybe reply: SherefMohamed@xxxxxxx: "Re: access-expression"
• Maybe reply: zhangxianqi: "Re: access-expression"
• Maybe reply: Fred Ingham: "Re: access-expression"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:26:02 GMT-3