From: china1124 (china1124@xxxxxxxxxxxx)
Date: Fri Dec 15 2000 - 04:44:25 GMT-3
i have three routers connect via frame-relay ,R1 is hub and R2 R3 is spoke, i c
onfig R3 is RP with sparse-mode and use loopback0 ,when i ping from R1 is fine,
but from R3 is fail.i ping about 8-9 times,it is sucess,but about 3 min ,i ping
again and it is fail,
can anybody tell me how to configure or explain. (my ios verion is 11.2)
thanks !
following is config:
R1:
interface Serial0
ip address 132.7.1.1 255.255.255.240
ip pim sparse-mode
ip pim nbma-mode
encapsulation frame-relay
ip ospf network broadcast
ip ospf priority 10
frame-relay map ip 132.7.1.2 100 broadcast
frame-relay map ip 132.7.1.3 200 broadcast
no frame-relay inverse-arp
ip pim rp-address 132.7.3.1
R2:
interface Serial0
ip address 132.7.1.2 255.255.255.240
ip pim sparse-mode
ip igmp join-group 224.1.1.1
encapsulation frame-relay
ip ospf network broadcast
ip ospf priority 0
frame-relay map ip 132.7.1.1 101 broadcast
frame-relay map ip 132.7.1.3 101 broadcast
no frame-relay inverse-arp
ip pim rp-address 132.7.3.1
R3:
interface loopback 0
ip addr 132.7.3.1 255.255.255.0
ip pim sparse-mode
interface e0
ip add 172.1.1.1 255.255.255.0
ip pim spares-mode
interface Serial0
ip address 132.7.1.3 255.255.255.240
ip pim sparse-mode
ip igmp join-group 224.1.1.1
encapsulation frame-relay
ip ospf network broadcast
ip ospf priority 0
frame-relay map ip 132.7.1.1 201 broadcast
frame-relay map ip 132.7.1.2 201 broadcast
no frame-relay inverse-arp
other question:Who can make sure whether lane in lab or not?
ÌìÏÂ֮ʣ¬Æ¥·òÓÐÔð¡£ChinaRenÐÂÎÅÈÃÄãÖ¸µã½É½¡£
http://news.chinaren.com
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:26:02 GMT-3