From: Wu, Jiang (wujiang@xxxxxxxxx)
Date: Tue Dec 05 2000 - 09:47:11 GMT-3
The bridge numbers need not to be unique throughout the SRB network. While the
ring numbers need to. The source-route bridge uses ring-bridge-ring combination
to recognize routes. So you can select bridge number as you like -- in accessa
ble range though.
Am I wrong again?
Wu
----- Original Message -----
From: Justin Menga <Justin.Menga@computerland.co.nz>
To: <ccielab@groupstudy.com>
Sent: Tuesday, December 05, 2000 5:25 PM
Subject: SR/TLB
> Hi,
>
> I have a few questions on SR/TLB
>
> sample config:
>
> source-bridge ring-group 1000
> source-bridge transparent 1000 2000 2 1
>
> bridge 1 protocol ieee
>
> int to0
> source-bridge 10 2 1000
>
> int e0
> bridge-group 1
>
> In the above config, the problem I have understanding is the transparent
> command, particularly the last two numbers. The third number is the "bridge
> no of the bridge that leads to the transparent bridging domain". Does this
> mean the bridge as specified in the source-bridge command under to0. THe
> fourth number is the number of the TB-Group - I understand this.
>
> I have seen configs that use different bridge numbers than those under the
> interfaces - will this still work?
>
> Last question: In a SRB network (without DLSW), do the bridge numbers have
> to be unique?? (I know the ring numbers need to be)
>
> Regards - 14 days in SYDNEY.....
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:25:58 GMT-3