From: Ronnie Royston (RonnieR@xxxxxxxxxxxxxxxxx)
Date: Mon Dec 04 2000 - 21:13:24 GMT-3
debug dialer
-----Original Message-----
From: Piperw222@aol.com [mailto:Piperw222@aol.com]
Sent: Monday, December 04, 2000 3:02 PM
To: ccielab@groupstudy.com
Subject: CCIE BOOT CAMP LAB 5 ISDN
Can anyone help me with my problem.. router 5 and 6 are configured for
ISDN... The configs state that the interface is configured as non broadcast.
however, when I pull the link from r6 as (as required) routes do not come in
through bri0 ) There is no OSPF adja with r5. there is however a direct link
and i can ping the directly conn bri 0 on r5. I found that on the configs
attached to hardcopy of lab requirement it shows that the link should be
point -to- point ... So I changed the bri int to point-to-point. Now I have
all the routes come in through isdn when the link is pulled.. But I also
have the bri int come up and down as per (the dialer idle - timeout 60 ) I
have ospf demand cir -- enabled which supress hellos, so what is causing the
bri int to come up.... The requirements state that it should only come up
when the link is cut to frame relay cloud on r6.
Any help would be appreciated
thanks
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:25:58 GMT-3