From: Justin Menga (Justin.Menga@xxxxxxxxxxxxxxxxxx)
Date: Sun Dec 03 2000 - 16:17:51 GMT-3
Hi,
Does anyone know if you can run NLSP over a Tunnel interface that uses
IPXWAN? I can't get it to go (no NLSP neighbors detected on either). If I
use IPX networks rather than IPXWAN, works OK. If I use RIP with IPXWAN
tunnels, works OK.
R1--------R2
R1:
ipx routing
ipx internal-network 1000
int tu0
tunnel source 10.1.1.1
tunnel destination 10.1.1.2
ipx ipxwan
ipx nlsp enable
int s0
ip address 10.1.1.1 255.255.255.0
ipx router nlsp
area-address 0 0
R2:
ipx routing
ipx internal-network 2000
int tu0
tunnel source 10.1.1.2
tunnel destination 10.1.1.1
ipx ipxwan
ipx nlsp enable
int s0
ip address 10.1.1.2 255.255.255.0
ipx router nlsp
area-address 0 0
Regards,
Justin Menga MCSE+I CCNP CCSE ASE
WAN Specialist
Computerland New Zealand
PO Box 3631, Auckland
DDI: (+64) 9 360 4864 Mobile: (+64) 25 349 599
mailto: justin.menga@computerland.co.nz
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:25:58 GMT-3