From: Simon Hopkins (simon@xxxxxxxxxxxxx)
Date: Thu Nov 01 2001 - 11:04:32 GMT-3
I have had this very problem. You need to disable IP routing on r1 & r3.
----- Original Message -----
From: yujianchun <stiff.yu@datacraft-asia.com>
To: radha rani <radhaccie@hotmail.com>; <ccielab@groupstudy.com>
Sent: Wednesday, November 01, 2000 9:52 AM
Subject: Re:
> can you tell result? I wait for you.
> -----Original Message-----
> From: radha rani <radhaccie@hotmail.com>
> To: ccielab@groupstudy.com <ccielab@groupstudy.com>
> Date: 28 October 2000 06:43
>
>
> >Hello,
> > I have a very simple SRB configuration which is not working. I
> >would be very grateful if someone could shed some light on this.
> >
> >My topology is :
> >
> >r1 --- ring100---r4---ring300---r3
> >
> >r1 and r3 are acting as hosts and have ip addresses 10.10.1.1/24 and
> >10.10.1.3/24 resp. r4 is the source-route-bridge. I am unable to ping
> >r1 and r3 from each other.
> >
> >Thanks for your help.
> >
> >R4's config is as follows:
> >
> >r4#sh run
> >Building configuration...
> >
> >Current configuration:
> >!
> >version 11.2
> >no service password-encrypt
> >no service udp-small-server
> >no service tcp-small-server
> >!
> >hostname r4
> >!
> >!
> >!
> >interface Serial0
> >no ip address
> >shutdown
> >!
> >interface Serial1
> >no ip address
> >shutdown
> >!
> >interface TokenRing0
> >no ip address
> >ring-speed 16
> >source-bridge 100 1 300
> >!
> >interface TokenRing1
> >no ip address
> >ring-speed 16
> >source-bridge 300 1 100
> >!
> >no ip classless
> >!
> >!
> >line con 0
> >line aux 0
> >line vty 0 4
> >login
> >!
> >end
> >
> >r4#
> >
> >-Radha
> >
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:25:39 GMT-3