From: Ronnie Royston (RonnieR@xxxxxxxxxxxxxxxxx)
Date: Mon Oct 30 2000 - 14:11:25 GMT-3
I have seen alot of emails concerning OSPF on-demand circuits.
Specifically, it has been said the correct way to configure it is to put the
demand circuit command on ONLY one side of the connection, even though it
will work properly if configured on both.
The Cisco Documentation says, "If the router is part of a point-to-point
topology, only one end of the circuit needs to be configured with this
command, but both routers need to have this feature loaded." What does that
mean? How do you load the feature without putting 'ip ospf demand-circuit'
on both routers? Also, it makes sense to me to put the command on either
the area 0 router or the remote router. Which router is preferred for this
command?
Any advice is greatly appreciated.
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:25:32 GMT-3