From: JKimes1@xxxxxxx
Date: Sun Oct 29 2000 - 00:25:40 GMT-3
Here's my predicament... I can't seem to get the tunnel on one side up.
Here's what I'm looking at:
hostname RouterA
!
appletalk routing eigrp 1
appletalk route-redistribution
!
interface Tunnel1
no ip address
no ip directed-broadcast
appletalk cable-range 600-600 600.79
appletalk zone test
appletalk protocol eigrp
tunnel source Ethernet0
tunnel destination 195.1.1.1
!
interface Ethernet0
ip address 194.1.1.1 255.255.255.0
no ip directed-broadcast
no keepalive
appletalk cable-range 400-499 410.1
appletalk zone accounting
appletalk zone service
hostname RouterC
!
appletalk routing eigrp 3
appletalk route-redistribution
!
interface Tunnel1
no ip address
no ip directed-broadcast
appletalk cable-range 600-600 600.95
appletalk protocol eigrp
tunnel source Ethernet0
tunnel destination 194.1.1.1
!
interface Ethernet0
ip address 195.1.1.1 255.255.255.0
no ip directed-broadcast
no keepalive
appletalk cable-range 500-599 599.1
appletalk zone sales
appletalk zone service
!
RouterC#sh apple int tu1
Tunnel1 is up, line protocol is up
AppleTalk node down, Port configuration error
AppleTalk cable range is 600-600
AppleTalk address is 600.95, Invalid
AppleTalk zone is not set.
Routing protocols enabled: RTMP & EIGRP
AppleTalk address gleaning is not supported by hardware
AppleTalk route cache is not initialized
I have tried different addresses, and they all come up invalid...
Any ideas?
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:25:31 GMT-3