From: Roger Dellaca (rdellaca@xxxxxxxxxx)
Date: Wed Oct 11 2000 - 13:02:34 GMT-3
In my experience, no dialer string is the correct method. I had a situation wi
th different dialer-list on both sides, and don't recommend it, because even th
ough the dialing end is not counting down the idle timeout (because pakets matc
h its dialer-list), the receiving end is (because it hasn't received anything i
t considers "interesting" according to its dialer list), the receiving end will
disconnect the call causing the dialing end to dial again.
>>> "Derek Buelna" <dameon@aracnet.com> 10/10 11:13 PM >>>
I was under the impression you could do this:
Legacy: physical interface - dialer map with a dial string on one end and no
dial string on the other.
DDR: dialer interface - no map of course - no dial string on one end as
above.
If he doesn't have a dial string, he can't call, right?
I guess the debugs would say that he would try and call but no dial string.
Do any of you have any thoughts on this?
It is obviously important to have this configured properly so that only one
side will ever try to dial.
-Derek
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Daniel Keller
Sent: Tuesday, October 10, 2000 7:50 PM
To: sbhakta@charter.net; ccielab@groupstudy.com
Subject: Re: ISDN Question
Do this on the non-calling router:
Int bri0
dialer-group 1
dialer-list 1 protocol ip deny
Then no traffic will ever trigger a call.
Dan Keller
>>> "Sanjay Bhakta" <sbhakta@charter.net> 10/10/00 09:31PM >>>
It is possible to set one side to be the calling and we will not have to use
dialer maps on the called router for IP and IPX. The IOS will create dialer
maps dynamically.
What if you are also routing appletalk or decnet over ISDN and you want to
make sure only one side will be initiating calls. I suppose we can create
dialer maps on the called router with a wrong dialer string, which I have
done and seems to work fine.
Is there another way?
********
Sanjay Bhakta (Halifax 10/18)
sbhakta@charter.net
sanjaybhakta@hotmail.com
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:25:25 GMT-3