From: Sam Munzani (sam@xxxxxxxxxxx)
Date: Wed Oct 11 2000 - 13:37:20 GMT-3
That's correct and wrong. I have used dialer maps with remote router name
but no dialer string under 12.0. However I couldn't do that under 11.2
during my lab attempt. I drove me crazy because you need a dialer map so
remote router can send you packets when like is active. When session is
active it creates a dynamic on remote router and I end up taking that to
keep going.
In 12.0 it is possible for sure.
Sam
> It does not look like you can enter a dialer map without dialer string on
> legacy ddr.
>
> Sanjay Bhakta (RTP 10/18)
> sbhakta@charter.net
> sanjaybhakta@hotmail.com
> ----- Original Message -----
> From: "Derek Buelna" <dameon@aracnet.com>
> To: <ccielab@groupstudy.com>
> Sent: Wednesday, October 11, 2000 1:13 AM
> Subject: RE: ISDN Question
>
>
> > I was under the impression you could do this:
> >
> > Legacy: physical interface - dialer map with a dial string on one end
and
> no
> > dial string on the other.
> > DDR: dialer interface - no map of course - no dial string on one end as
> > above.
> >
> > If he doesn't have a dial string, he can't call, right?
> > I guess the debugs would say that he would try and call but no dial
> string.
> >
> > Do any of you have any thoughts on this?
> > It is obviously important to have this configured properly so that only
> one
> > side will ever try to dial.
> >
> > -Derek
> >
> > -----Original Message-----
> > From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
> > Daniel Keller
> > Sent: Tuesday, October 10, 2000 7:50 PM
> > To: sbhakta@charter.net; ccielab@groupstudy.com
> > Subject: Re: ISDN Question
> >
> > Do this on the non-calling router:
> >
> > Int bri0
> > dialer-group 1
> >
> >
> > dialer-list 1 protocol ip deny
> >
> > Then no traffic will ever trigger a call.
> >
> > Dan Keller
> >
> >
> > >>> "Sanjay Bhakta" <sbhakta@charter.net> 10/10/00 09:31PM >>>
> > It is possible to set one side to be the calling and we will not have to
> use
> > dialer maps on the called router for IP and IPX. The IOS will create
> dialer
> > maps dynamically.
> >
> > What if you are also routing appletalk or decnet over ISDN and you want
to
> > make sure only one side will be initiating calls. I suppose we can
create
> > dialer maps on the called router with a wrong dialer string, which I
have
> > done and seems to work fine.
> >
> > Is there another way?
> >
> > ********
> > Sanjay Bhakta (Halifax 10/18)
> > sbhakta@charter.net
> > sanjaybhakta@hotmail.com
> >
> >
> >
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:25:25 GMT-3