From: Maljure, Sanjay (smaljure@xxxxxxxxxxxxxxxxx)
Date: Sun Oct 01 2000 - 21:29:35 GMT-3
Hi Sanjay
Basically there is the issue of "half-bridge" on R3
U have ipx network 700 configured on serial of r3
So, when u initiate an ipx ping from R3 to the BVI of r1, the
encapsulation will be IPX directly in HDLC...
This will work if u configure a BVI on R3 with IPX net 700 and source
the ping from this interface
Sanjay
-----Original Message-----
From: Sanjay Bhakta [mailto:sbhakta@charter.net]
Sent: Sunday, October 01, 2000 8:02 PM
To: CCIE Group Study (E-mail)
Subject: IRB Question
I have confgured IRB on r1. IPX network 700 is configured on r3. On
r3, I can see all the routes learned from BVI, however when I try to
ping ipx interface on r1 don't get replay. I turned on debug ipx
packets on r1 and I don't even see the ping request coming from r3.
Below are the related configs. Any suggestions?
Thanks.
r1 --------ethernet-----------r2---------serial---------r3
config on r1:
bridge 1 protocol ieee
int eth0
bridge-group 1
int bvi 1
ipx network 700
bridge 1 route ip
bridge 1 route ipx
bridge 1 route apple
bridge 1 route dec
no bridge 1 bridge ip
no bridge 1 bridge apple
no bridge 1 bridge dec
config on r2:
bridge 1 protocol ieee
int eth0
bridge-group 1
int serial 0
bridge-group 1
config on r3
bridge 1 protocol ieee
int eth0
ipx network 750
bridge-group 1
int serial 0
ipx network 700
bridge-group 1
********
Sanjay Bhakta (RTP 10/18)
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:25:22 GMT-3