From: Mark Lewis (markl11@xxxxxxxxxxx)
Date: Sun Oct 01 2000 - 21:28:35 GMT-3
Try a config like this:
r1:
int e0
ipx netw 700
(no bridging here/no irb here)
r2:
(ipx routing OFF here)
bridge 1 prot ieee
int e0
bridge-group 1
int s0
bridge-group 1
r3:
bridge 1 prot ieee
bridge irb
int s0
bridge-group 1
int bvi1
ipx netw 700
bridge 1 bridge ipx
bridge 1 route ipx
Hope that helps,
Mark
>From: "Sanjay Bhakta" <sbhakta@charter.net>
>Reply-To: "Sanjay Bhakta" <sbhakta@charter.net>
>To: "CCIE Group Study \(E-mail\)" <ccielab@groupstudy.com>
>Subject: IRB Question
>Date: Sun, 1 Oct 2000 19:02:05 -0500
>
>I have confgured IRB on r1. IPX network 700 is configured on r3. On r3, I
>can see all the routes learned from BVI, however when I try to ping ipx
>interface on r1 don't get replay. I turned on debug ipx packets on r1 and
>I don't even see the ping request coming from r3.
>
>Below are the related configs. Any suggestions?
>
>Thanks.
>
>
>r1 --------ethernet-----------r2---------serial---------r3
>
>
>config on r1:
>
>bridge 1 protocol ieee
>
>int eth0
>bridge-group 1
>
>int bvi 1
>ipx network 700
>
>bridge 1 route ip
>bridge 1 route ipx
>bridge 1 route apple
>bridge 1 route dec
>no bridge 1 bridge ip
>no bridge 1 bridge apple
>no bridge 1 bridge dec
>
>
>config on r2:
>
>bridge 1 protocol ieee
>
>int eth0
>bridge-group 1
>
>int serial 0
>bridge-group 1
>
>
>config on r3
>
>
>bridge 1 protocol ieee
>
>int eth0
>ipx network 750
>bridge-group 1
>
>int serial 0
>ipx network 700
>bridge-group 1
>
>
>********
>Sanjay Bhakta (RTP 10/18)
>
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:25:22 GMT-3