From: Matt C. Lange (mattclange@xxxxxxxxxxxx)
Date: Thu Sep 28 2000 - 12:20:17 GMT-3
virtual interfaces are loopback addresses.
IE int lo0
ip address 1.1.1.1 255.255.255.255
You can then set this as your router id
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Omar Baceski
Sent: Thursday, September 28, 2000 9:44 AM
To: ccielab@groupstudy.com
Subject: RE: ospf virtual interfaces and non-backbone connected areas
i think virtualinterfaces stands for subinterfaces (you can find i a seveal
places in the cisco docs)
so fatkid is asking you how to gain full conectivity with x.25 physical
interfaces.
> -----Mensaje original-----
> De: Connary, Julie Ann [SMTP:jconnary@cisco.com]
> Enviado el: Jueves, 28 de Septiembre de 2000 09:52 a.m.
> Para: ccielab@groupstudy.com
> Asunto: ospf virtual interfaces and non-backbone connected areas
>
> Hi all,
>
> On www.fatkid.com their is an Expert Redistribution lab #502. The topology
>
> has the area backbone on the token ring interface of a
> router. The same router is connected to an X.25 cloud of 3 routers. The
> X.25 cloud is area 4. One of the spoke routers has an ethernet
> on which another area resides- area 2. The lab instructions say to make
> sure that complete ospf connectivity
> occurs but do not use virtual interfaces to accomplish this.
>
> I am assuming that virtual interfaces means virtual links? So how else can
>
> you connect a non-backbone connected area
> to the backbone if you do not use a virtual link?
>
> Thanks in advance,
>
> Julie Ann
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:25:08 GMT-3