RE: OSPF route ib database, not in table

From: smaljure@xxxxxxxxxxxxxxxxx
Date: Sat Sep 23 2000 - 01:46:52 GMT-3

• Next message: Muthu: "Password recovery for Catalyst 2900 series"
• Previous message: John Conzone: "OSPF route ib database, not in table"
• Maybe in reply to: John Conzone: "OSPF route ib database, not in table"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

   
   Can u post the OSPF database?
   Sanjay
   
   -----Original Message-----
   From: John Conzone [mailto:jkconzone@home.com]
   Sent: Friday, September 22, 2000 7:24 PM
   To: ccielab
   Subject: OSPF route ib database, not in table
   
       Frame relay hub and spoke. NON broadcast, neighbors defined. Hub
   is DR. LIfe is good. Routes exchanged between all areas connected to
   area 0. Configure virtual circuit from one spoke to hub. Virtual link
   is up on both sides. Partitioned network is in OSPF database, but NOT
   in table.
   
       Change OSPF network type on hub/spokes to Point-to-Mutlipoint,
   virtual link comes up again and route is in table.
   
       I'm searching Doyle's book, but am looking for some insight on
   this.

• Next message: Muthu: "Password recovery for Catalyst 2900 series"
• Previous message: John Conzone: "OSPF route ib database, not in table"
• Maybe in reply to: John Conzone: "OSPF route ib database, not in table"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:25:00 GMT-3