From: Bill Dellamar (wdellamar@xxxxxxxxx)
Date: Fri Sep 22 2000 - 09:03:58 GMT-3
All,
the config register was 0x101. I had thought it was
0x102. Anyway, it took me an hour reading cisco docs
to find out how to change the config register since
the ags does not support the conf-reg command. It
appears to be working fine now.
Thanks for all your input.
Bill
--- Jim Jones <jonesx4@earthlink.net> wrote:
> Make sure there is a jumper on the CSC3 or CSC4 card
> at the far right
> hand side.
> This is the 0 position. There should be another
> jumper on number 8. This
> is your
> console baud rate. The far right jumper means boot
> from config. If the
> jumper is not on 0, but on 15 you could be in
> password recovery mode,
> but you would have went to rommon first.
> You could also have a flash memory board
> (optional) that could have
> went south.
>
> Bill Dellamar wrote:
>
> > I have an ags+ that loses the config everytime I
> > remove power from it. The write mem says it
> works,
> > but then I remove power from the box and then
> reapply
> > it, the config is lost. I've searched the docs
> and
> > cant' find like a battery backup or anything. Is
> the
> > EEPROM bad or is there a battery backup for the
> NVRAM?
> >
> > Thanks,
> >
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:25:00 GMT-3