From: Jim Jones (jonesx4@xxxxxxxxxxxxx)
Date: Fri Sep 22 2000 - 00:25:48 GMT-3
Make sure there is a jumper on the CSC3 or CSC4 card at the far right
hand side.
This is the 0 position. There should be another jumper on number 8. This
is your
console baud rate. The far right jumper means boot from config. If the
jumper is not on 0, but on 15 you could be in password recovery mode,
but you would have went to rommon first.
You could also have a flash memory board (optional) that could have
went south.
Bill Dellamar wrote:
> I have an ags+ that loses the config everytime I
> remove power from it. The write mem says it works,
> but then I remove power from the box and then reapply
> it, the config is lost. I've searched the docs and
> cant' find like a battery backup or anything. Is the
> EEPROM bad or is there a battery backup for the NVRAM?
>
> Thanks,
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:25:00 GMT-3