From: abdul_rahim@xxxxxxxxxxxxxx
Date: Wed Sep 20 2000 - 14:23:05 GMT-3
When your Supervisor Engine boots up press Enter with in first 30 secs of
its Booting up from the console and you'll get into the user mode with out
needing any passwords
Thanks
Abdul Rahim
"Lei Chen" <leichen@cisco.com>@groupstudy.com on 09/20/2000 10:05:37 AM
Please respond to "Lei Chen" <leichen@cisco.com>
Sent by: nobody@groupstudy.com
To: "Rupawala, Honeid" <rupawala@SOLUTIONS.ATT.com>
<ccielab@groupstudy.com>
cc:
Subject: Re: CAT5K password recovery.
I think you have to power off the machine and power on again, not just
reset
system.
----- Original Message -----
From: "Rupawala, Honeid" <rupawala@SOLUTIONS.ATT.com>
To: <ccielab@groupstudy.com>
Sent: Wednesday, September 20, 2000 8:21 AM
Subject: CAT5K password recovery.
> Hi team,
>
> Can anyone tell me how is the password recovery on the Catalyst 5000
> successfully done. It is said that the password is not effective till the
> first 30 sec.
> When does this 30 sec. period start ? Immediately after I get the boot
> messages on the console OR after the bootstrap loads OR after I get the
> Console >
> prompt ?
>
> I tried all 3 ways above, but no luck. Pls. help.
>
> Regards
>
> Honeid Rupawala.
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:24:59 GMT-3