From: Andrew (arousch@xxxxxxxx)
Date: Wed Sep 20 2000 - 01:46:06 GMT-3
Please paste your config. You're vague at best
At 10:50 PM 9/19/00 +0000, damien wrote:
>Does any body know are there any issues with Configuring NAT in both
>directions and running the outside interface on a Frame Relay Interface.
>
>I can see the translations taken correctly, in and out. But the return
>packets (after being translated correctly) are not making it over the
>Frame Relay interface, I can see no map entries when debugging frame
>packet. The Frame Circuit is point to point PVC, and the dynamic map entry
>for the remote IP is in the frame inarp-cache. I do not understand the no
>map messages. If I put in a manual map entry for the the destination
>translation it works...........!!!!!!!!
>
>Anyone any experience with this.......I will try the configs out on
>Ethernet in the Lab later, but just wondered is there something obvious.
>
>On the Cisco NAT FAQ, it mentions there are no issues over frame on
>inbound translations, thats all it says ???????
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:24:58 GMT-3