From: Marc Russell (mrussell@xxxxxxxxxxxxxx)
Date: Wed Sep 06 2000 - 23:03:09 GMT-3
Title: atm configuration question
I would also setup PVCs on the LS1010 and then pretend the proctor did
it. Learn how to use the IOS capabilities of the routers to auto
discover the PVCs that were created. The proctor may not give you the
VPI/VCI info. It may be up to you to figure them out on your own.
-----Original Message-----
From: Sam Munzani [mailto:sam@munzani.com]
Sent: Wednesday, September 06, 2000 9:35 PM
To: John Conzone; Hammond, Doug; ccielab@groupstudy.com
Subject: Re: atm configuration question
Do SVC and you don't have to configure LS1010 at all.
Sam
----- Original Message -----
From: John Conzone
To: Hammond, Doug ; ccielab@groupstudy.com
Sent: Wednesday, September 06, 2000 7:38 PM
Subject: Re: atm configuration question
Doug, the CCIE requirements state that the candidate will not be
required to set up the LS1010, at least last time I looked.
I've set up PVC through the 1010 and lane on it using Marc's lab,
but do you know something new? Is LS1010 configuration a requirement
now?
----- Original Message -----
From: Hammond, Doug
To: ccielab@groupstudy.com
Sent: Wednesday, September 06, 2000 7:56 PM
Subject: atm configuration question
23 days to go and setting up ATM is really frosting my oats today.
Does anyone have an example of how an LS1010 would be set up to
accommodate the ATM scenarios I may see shortly? I have a LS1010,
cat5k with a LANE board, and a 3640 with an ATM board. Setting up
LANE was relatively easy, but I seem to be stuck on setting up the
LS1010 and rtr to talk CLIP. Any ideas?
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:24:53 GMT-3