From: Muthu (muthumon@xxxxxxx)
Date: Wed Sep 06 2000 - 22:24:48 GMT-3
1)In svc environment you need not configure anything for LS1010.
Just write erase to put into factory default.
2) If you using it for LANE, in some situation you may have to give
configuration servers ATM address.
( The cases where you are not using well known LECS address )
3. In PVC environment just create PVCs. Exactly similar to frame relay switch
configuration. It is very simple.See Bruce Caslow book
Hope this will help.
"Hammond, Doug" <DHammond@bns.nec.com> wrote:
> ---------------------------------------------
> Attachment:
> MIME Type: multipart/alternative
> ---------------------------------------------
No, as far as I know we don't have to set up an ATM switch. But, I need to
set up an ls1010 that dropped in my lap with no config on it. I seriously
need to get some hands-on ATM practice. As Dennis Miller, would say, I don't
want to get on a rant here, but, I don't get a chance to test the twisted
configs we get to play with in the lab! No offense to those of you who like
setting up appletalk or IPX over ATM.
-----Original Message-----
From: John Conzone [mailto:jkconzone@home.com]
Sent: Wednesday, September 06, 2000 5:38 PM
To: Hammond, Doug; ccielab@groupstudy.com
Subject: Re: atm configuration question
Doug, the CCIE requirements state that the candidate will not be
required to set up the LS1010, at least last time I looked.
I've set up PVC through the 1010 and lane on it using Marc's lab, but do
you know something new? Is LS1010 configuration a requirement now?
----- Original Message -----
From: Hammond, <mailto:DHammond@bns.nec.com> Doug
To: ccielab@groupstudy.com <mailto:ccielab@groupstudy.com>
Sent: Wednesday, September 06, 2000 7:56 PM
Subject: atm configuration question
23 days to go and setting up ATM is really frosting my oats today. Does
anyone have an example of how an LS1010 would be set up to accommodate the
ATM scenarios I may see shortly? I have a LS1010, cat5k with a LANE board,
and a 3640 with an ATM board. Setting up LANE was relatively easy, but I
seem to be stuck on setting up the LS1010 and rtr to talk CLIP. Any ideas?
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:24:53 GMT-3