From: Brian Best (bbest@xxxxxxxxxxxxxxxx)
Date: Sat Aug 26 2000 - 11:42:18 GMT-3
You need the command lane config-atm-address <NSAP of LECS> on the
interface.
http://www.cisco.com/univercd/cc/td/doc/product/software/ios120/12cgcr/switc
h_r/xrlane.htm#xtocid776059
Regards,
Brian Best - CCIE #6128
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Matt Lachberg 3
Sent: Saturday, August 26, 2000 7:51 AM
To: ccielab@groupstudy.com
Subject: static lane question
Why do I need a LECS if I specify the client, bus, and server NSAP's
manually, Why is the client stuck in Initialstate? Any clues?
interface ATM0.3 multipoint
ip address 10.10.30.5 255.255.255.0
no ip directed-broadcast
lane client-atm-address 47.0091810000000050E2058501.00000C34B43A.03
lane server-atm-address 47.0091810000000050E2058501.00000C34B43B.03
lane bus-atm-address 47.0091810000000050E2058501.00000C34B43C.03
lane server-bus ethernet elan3
lane client ethernet elan3
!
LE Server ATM0.3, Elan name: elan3, Admin: up, State: operational
Master/Backup: Backup, Type: ethernet, Max Frame Size: 1516
locally set elan-id: not set
elan-id obtained from LECS: not set
ATM address: 47.0091810000000050E2058501.00000C34B43B.03
LECS used: 47.007900000000000000000000.00A03E000001.00 NOT yet connected
LE BUS ATM0.3, Elan name: elan3, Admin: up, State: operational
Type: ethernet, Max Frame Size: 1516
ATM address: 47.0091810000000050E2058501.00000C34B43C.03
LE Client ATM0.3 ELAN name: elan3 Admin: up State: initialState
Client ID: unassigned Next join attempt in 76 seconds
Join Attempt: 27
Known LE Servers: 0
Last Fail Reason: Timeout on join request
HW Address: 0000.0c34.b43a Type: ethernet Max Frame Size: 1516
ATM Address: 47.0091810000000050E2058501.00000C34B43A.03
VCD rxFrames txFrames Type ATM Address
0 0 0 configure
00.000000000000000000000000.000000000000.00
Matthew Lachberg, CCNP, CCDP, MCSE
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:24:30 GMT-3