From: smaljure@xxxxxxxxxxxxxxxxx
Date: Fri Aug 25 2000 - 11:09:32 GMT-3
One possible way to do this is to define the loopback interface in a
separate area and summarize the /32 route from this area in to area 0 as a
/24 (say) using the "area x range ...." command.
Sanjay
> -----Original Message-----
> From: Simon Baxter [mailto:Simon.Baxter@au.logical.com]
> Sent: Friday, August 25, 2000 9:51 AM
> To: CCIE Group Study (E-mail)
> Subject: 2nd attempt at a question!!
>
> I'm doing a test lab which has asked me if there's any way to advertise
> routes to loopback interfaces as anything but /32 routes.
>
> I can't see any way around this :
>
> Link connected to: a Stub Network
> (Link ID) Network/subnet number: 130.130.33.1
> (Link Data) Network Mask: 255.255.255.255
> Number of TOS metrics: 0
> TOS 0 Metrics: 1
>
> R4#sh ip os int lo0
> Loopback0 is up, line protocol is up
> Internet Address 130.130.33.1/24, Area 0.0.0.0
> Process ID 10, Router ID 130.130.33.1, Network Type LOOPBACK, Cost: 1
> Loopback interface is treated as a stub Host
> R4#
>
>
> No matter what I do, it always stays as "Loopback interface is treated as
> a stub Host"
>
>
> Is this a trick question???
>
> I'm losing WAY too much sleep over it..
>
>
> Simon
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:24:30 GMT-3