From: pbosio@xxxxxxxxxxxxxx
Date: Tue Aug 08 2000 - 04:54:24 GMT-3
Appletalk,
Mmmm, save and reboot...
hello
those parameters are already in;but spoke 2 & 3 never become active in
appletalk. (their node number is showing as valid.)
Any clue pls..
Tx n Rd
>From: "Tom Gonter" <tgonter@cisco.com>
>Reply-To: "Tom Gonter" <tgonter@cisco.com>
>To: "Varghese Thomas" <vnthomas@hotmail.com>, "'Ccielab"
><ccielab@groupstudy.com>
>Subject: RE: Appletalk & EIGRP over a NBMA
>Date: Mon, 7 Aug 2000 21:14:54 -0500
>
>You need to use no appletalk eigrp-splithorizon on your hub multipoint sub
>interface. The split horizon you're using is for IP routing updates not
>appletalk routing. Also note is you move to plain vanilla RTMP you'll need
>no appletalk rtmp-splithorizon on the multipoint subinterface.
>
>See
>
>http://www.cisco.com/univercd/cc/td/doc/product/software/ios121/121cgcr/atip
>x_c/2cdapple.htm#xtocid17069133
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
>Varghese Thomas
> Sent: Monday, August 07, 2000 5:10 PM
> To: 'Ccielab
> Subject: Appletalk & EIGRP over a NBMA
>
>
> Hello,
>
> The set-up is 1 hub with 4 sopkes running EIGRAP in a FR cloud
>
> Hub has the following conf.
>
> no split horizon disabled
> appletalk local routing
>
> Common settings in hub & sopke
>
> appletalk routing egirp XX (xx is uniuqe )
>
> network wan
> appletalk protocol eigrp
> no appletalk protocol rtmp
> no frame-realy inver-arp
>
> In addition, all routers have proper PVC statements
>
> Issue:
>
> Hub(r1) & one of the spoke(4) works fine with their FR. AT. int comes
>up.
> sopke 2 & 3 never comes up in terms of AT int. Hub's cable/zone is
>gettings verified by either r2 or r3 or even with r4(case by case) as well
>as spoke 4 is also getting verified by rest of the routers.
>
> r2 & r3 shows "aquiring port net information", but never gets
>established
>and status of the resp. AT int is down.
> I tried without EIGRP also, but the result is the same.
>
> Both spoke 2 &3 is running IOS 12.0(3)T3 and hub is 11.0(3) & spoke 4 is
>12.0(1)
>
> Any hints pls?
>
> Tx n RD
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:24:22 GMT-3