From: Art Davis (senzaart@xxxxxxx)
Date: Wed Aug 02 2000 - 09:50:29 GMT-3
Ah, "administratively prohibited." Check your access-list on R5. Cisco traces
use udp instead of icmp. You can do an extended trace to find the exact port.
Hi,
I am working on a CCIEbootcamp Lab 8 . however, I have a problem in
the X25 and ISDN backup. I found that there is a problem in the ISDN
line always up. This may due to the DSLW I setup. and I am now solving
on this. However, I found there is a strange trace 1 173.20.201.5 !A
* !A which is the trace from the R1 to the R5 through the X25 network.
Does any know what is this mean ?
I am ping from R1 to R5 173.20.201.5.
Ethernet---R1----X25----R5---Ethernet
\ |
\ ISDN |
\ |
R2 ------------------Ethernet
R1_16032#ping 173.20.201.5
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 173.20.201.5, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 8/8/8 ms
R1_16032#
R1_16032#trace 173.20.201.5
Type escape sequence to abort.
Tracing the route to 173.20.201.5
1 173.20.201.5 !A * !A
R1_16032#
R1 :
interface Serial0
ip address 173.20.201.2 255.255.255.0
encapsulation x25 dce
no ip mroute-cache
x25 address 225012
x25 map ip 173.20.201.5 52514 broadcast
x25 map ipx 201.2514.0001.0001 52514 broadcast
x25 map appletalk 201.5 52514 broadcast
appletalk cable-range 201-201 201.1
appletalk zone X25
ipx network 201
clockrate 2000000
!
R5 :
!
interface Serial1
ip address 173.20.201.5 255.255.255.0
ip access-group 101 in
no ip directed-broadcast
encapsulation x25
no ip mroute-cache
x25 address 52514
x25 map ip 173.20.201.2 225012 broadcast
x25 map ipx 201.1603.0002.0001 225012 broadcast
x25 map appletalk 201.1 225012 broadcast
appletalk cable-range 201-201 201.5
appletalk zone X25
appletalk distribute-list 601 out
decnet cost 10
ipx network 201
!
R1_16032#sh ip inter brie
Interface IP-Address OK? Method Status
Protocol
BRI0 173.20.100.1 YES NVRAM up
up
BRI0:1 unassigned YES unset up
up
BRI0:2 unassigned YES unset down
down
Ethernet0 173.20.203.1 YES NVRAM up
up
Loopback0 6.6.6.6 YES NVRAM up
up
Loopback1 160.10.10.1 YES NVRAM up
up
Loopback2 161.10.10.1 YES NVRAM up
up
Loopback3 170.10.10.1 YES NVRAM up
up
Serial0 173.20.201.2 YES NVRAM up
up
R1_16032#
R5_2514#sh ip inter brie
Interface IP-Address OK? Method
Status Prot
ocol
Ethernet0 173.20.202.5 YES NVRAM
up up
Ethernet1 unassigned YES NVRAM administratively
down down
Loopback0 5.5.5.5 YES NVRAM
up up
Loopback1 unassigned YES unset
up up
Serial0 unassigned YES NVRAM
up up
Serial0.1 173.20.200.5 YES NVRAM
up up
Serial1 173.20.201.5 YES NVRAM
up up
R5_2514#
R1_16032#sh dialer
BRI0 - dialer type = ISDN
Dial String Successes Failures Last called Last status
384020 11 0 00:01:49 successful
0 incoming call(s) have been screened.
0 incoming call(s) rejected for callback.
BRI0:1 - dialer type = ISDN
Idle timer (120 secs), Fast idle timer (20 secs)
Wait for carrier (30 secs), Re-enable (15 secs)
Dialer state is data link layer up
Dial reason: ip (s=173.20.203.1, d=173.20.202.6)
Time until disconnect 118 secs
Connected to 384020 (R6_16031)
BRI0:2 - dialer type = ISDN
Idle timer (120 secs), Fast idle timer (20 secs)
Wait for carrier (30 secs), Re-enable (15 secs)
Dialer state is idle
R1_16032#
rgds
> ---------------------------------------------
> Attachment: wlee.vcf
> MIME Type: text/x-vcard
> ---------------------------------------------
Arthur Davis
Network Engineer
Altra Energy Technologies
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:24:20 GMT-3