From: Brian Edwards (bedwards@xxxxxxxxxxx)
Date: Tue Jul 18 2000 - 15:59:00 GMT-3
Correct, they are two separate settings. With "encap frame" these are the
non-defaults...
interface Serial0
ip address 16.1.1.2 255.255.255.0
encapsulation frame-relay
ip split-horizon
no ip split-horizon eigrp 1
~~~~~~~~~
sh ip int s0, shows the split-horizon setting for RIP/IGRP
squid91#sh ip int s0
Serial0 is up, line protocol is up
......
Split horizon is enabled <<<<<< this is the split-horizon for
RIP/IGRP
........
~~~~~~~~~
I can't find a show command that displays whether EIGRP split-horizon is on
or not.
/Brian
> -----Original Message-----
> From: Kent [mailto:cciecn@yahoo.com]
> Sent: Tuesday, July 18, 2000 10:58 AM
> To: Lawrence Dwyer; John Conzone
> Cc: ccielab
> Subject: Re: Eigrp split horizon
>
>
> I think EIGREP is an exception.
>
> Kent
> --- Lawrence Dwyer <dwyer@tatrc.org> wrote:
> > In other words, it works like it is supposed to
> > after you enter the
> > command no split which should be default for that
> > config?
> >
> > According to Caslow,
> > SH is DIS on FR physical interfaces
> > SH is EN on FR point-2-point IP subints
> > SH is EN on FR multipt. subints
> >
> > Unless it is a bug in yur particular IOS ver.
> > I will try it tomorrow night with both 12.0 and 11.1
> > Larry
> >
> > John Conzone wrote:
> >
> > > I have a hub and spoke config with FR, and am
> > running EIGRP. The
> > > hub will not pass spoke routes to other spokes
> > unless I have split
> > > horizon disabled on the hub serial int. I am using
> > all physical
> > > interfaces. By default, split horizon should be
> > already disabled on a
> > > FR physical int. Anyone else run into this?
> >
>
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:23:54 GMT-3