From: kongck (kongck@xxxxxxxxxxxxxx)
Date: Sun Jun 25 2000 - 10:05:08 GMT-3
make a tunnel between r1 and r3.
----- Original Message -----
From: "Saleem Rahman" <srahman@lucent.com>
To: <ccielab@groupstudy.com>
Sent: Sunday, June 25, 2000 8:39 PM
Subject: IPX SAP QUESTION
> Hi All,
> I am facing a problem to support a IPX SAP question......unable to find
the
> answer.
>
> The scenario as follows.
>
> Q. R1 is advertising a Static SAP entry to downstream routers.....Using
IPX
> SAP filter only 'R2' should NOT see in the entry in is SAP table, but R3
> should be able to see it.
>
> IPX RIP all over.
>
> eth serail serial eth
> ---- R1--------|-------R2--------|------R3---
>
> Note : I tried to configure 'ipx input-sap filter' / '
> ipx-router-sap-filter' (Also, tried configuring IPX EIGRP on the serial
> links and used "distribute-list filtler"). It gets blocked at the R2 and
> eventually never gets propagaed to R3.
>
> Is there any other method to accomplish this scenario.
>
> Any kind of tips or helps will highly appreciable.
>
> Thanks in advance.
>
> Regards,
> Saleem
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:23:43 GMT-3