From: kongck (kongck@xxxxxxxxxxxxxx)
Date: Sun Jun 25 2000 - 09:25:02 GMT-3
Holbert,
I think you can use backup interface with snapshot routing, and the
snapshot server donot use the keyword "dialer".
>
> This is the scenario
>
> R1(Serial)-----------(Serial)R1
> (BRI)--------------(BRI)
>
> That is, the two routers have parallel paths between them, one serial and
> one ISDN. I was hoping to be able to use snapshot routing to backup the
> serial link. I increased the ipx ticks to allow the serial link to be the
> preferred route. If I do "ipx down" on the serial during the active
period,
> the backup works fine. During the quiet period, however, the bri routes
do
> not show up.
>
> I have come to the following conclusion regarding snapshot:
>
> Routes must be in the routing table for a "snapshot" to be taken.
>
> Can anyone confirm this? And if it is true, is there a way to use
snapshot
> as a backup interface?
>
> Matt Holbert
> Network Engineer
> Integrated Communication Solutions, Inc.
> 301-695-8800
> mholbert@icscorp.com
> http://www.icscorp.com
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:23:43 GMT-3