From: Dino (air@xxxxxxxxxx)
Date: Fri Jun 09 2000 - 07:32:07 GMT-3
Hi Kai,
I don't think you can do this without using protocol translation.
I tried it to get working with bridging awhile ago and it didn't work.
I found this note on the CD when I was trying to get it working:
LAT-to-LAT over Frame Relay or SMDS Example
To transport LAT traffic over a Frame Relay or an SMDS network, LAT must
first be translated to TCP. The TCP traffic is routed over the Frame
Relay network and then translated back to LAT on Router-B on Network B.
Thanks,
Dino
Wang, Kai wrote:
>
> I am trying to configure LAT over F/R without using the protocol
> translation. I am unable to get it to work.
>
> The configs are shown as follows:
>
> R4 config
> !
> interface Serial1
> mac-address 0004.0004.0004
> no ip address
> encapsulation frame-relay
> lat enabled
> !
> lat service TEST enabled
>
> R3 config
> !
> interface Serial0
> mac-address 0003.0003.0003
> no ip address
> encapsulation frame-relay
> lat enabled
> no fair-queue
>
> I am getting the following error message from my router:
>
> %LINK-3-BADMACREG: Interface Serial1, non-existent MACADDR registry for link
> 31
> -Process= "LAT Timers", ipl= 0, pid= 29
> -Traceback= 3451230 3450FB4 30F4892 363A7E4 363A986 364524C 363AB10
>
> What should I do to get it to work?
>
> Thank You!
>
> Kai Wang
> EDS - AHSMC/Network Operation
> MS 3010
> 300 East Big Beaver
> Troy, MI 48083
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:23:41 GMT-3