From: Muthu Mohanasundaram (mmsundar@xxxxxxxxx)
Date: Thu Jun 01 2000 - 16:09:22 GMT-3
Hi Rick,
lane config config-atm-address zzzzzzz...
says that zzzzzzzz... is the LECS address. This should
be configured on the main atm interface. This nsap
address will be registered with the switch through
ilmi. (show atm ilmi-status)
lane config-atm-address zzzzzzz.....
says to the client (LEC) to use zzzzzz.... to contact
the LECS. This should be configured on the
sub-interface where the LEC is configured.
Hope this is clear,
Gook Luck,
Mohan.
--- Greenjeepp@aol.com wrote:
> The command reference says the following:
>
> To specify a configuration server's ATM address
> explicitly, use the lane config-atm-address
> interface configuration command.
>
>
> lane [config] config-atm-address
>
> config
> (Optional) When the config keyword is used, this
> command applies only to the LANE configuration
> server (LECS). This keyword indicates that the LECS
> should use the 20-byte address that you explicitly
> entered.
>
> Does anybody know what else it does when you do not
> specify the optional keyword [config]. I believe
> either
> way will cause the LECS to listen on the manually
> configured address and that's it.
>
> Thanks
>
> Rick
>
>
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:23:40 GMT-3