From: Goh, Winston (winston.goh@xxxxxxxxxxxxx)
Date: Tue May 09 2000 - 22:54:32 GMT-3
hi,
since ospf is a link-state protocol, using distribue-list out ospf is rather
useless because ospf does not propagate routing table out its interface but
link states. Therefore, downstream routers will still receive the link
states and generate the routes. cheers
Winston Goh
CCNP, CVE
Snr Network Specialist
Unisys Singapore
mobile : 97469192
-----Original Message-----
From: Kevin Young [mailto:kvyoung@sina.com]
Sent: Tuesday, May 09, 2000 11:53 AM
To: Muthu Mohanasundaram
Cc: ccielab
Subject: Re: OSPF route filtering on ABRs...
Hi,
I think if you want to filter all of the routes from area 0 into the
area1 ,
you could config the ABR a totally-stubby area;
I couldn't be sure that you may use distribute-list xxx out ospf xxx
to filter partial toutes from area 0 into area 1, if you get answer, pls
tell me.
----- Original Message -----
From: Muthu Mohanasundaram <mmsundar@yahoo.com>
To: <ccielab@groupstudy.com>
Sent: Tuesday, May 09, 2000 10:09 AM
Subject: OSPF route filtering on ABRs...
> Hi,
>
> I have an ABR connecting 2 areas, say Area 0 and Area
> 1. Can I filter some or all of the routes from Area 0
> from entering Area 1.
>
> That is, can I filter routes while they are being
> passed between areas?
>
> Any ideas....
>
> Thanks,
>
> Mohan.
>
>
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:23:28 GMT-3