From: George Harizanov (georgehar@xxxxxxxxxxxxxx)
Date: Fri Apr 21 2000 - 09:57:45 GMT-3
Li
APPLETALK DISTRIBUTE-LIST works fine with EIGRP
you probably have to do SHUT - NO SHUT on the interface and clear the routes
in your routing table.
HTH
G
----- Original Message -----
From: "Li Chaoyong" <hughcyli@holybridge.com.cn>
To: "Goh, Winston" <winston.goh@sg.unisys.com>; <ccielab@groupstudy.com>
Sent: Wednesday, April 19, 2000 3:21 AM
Subject: Re: How to filter NETBIOS in DLSW PEER
> APPLETALK DISTRIBUTE-LIST can only filter RTMP routes, can not filter
EIGRP routes. I tried zip-reply-filter, zone information is filtered, but
routes is still there.
>
> I don't know how to do.
>
> Help, help.
>
> ----- Original Message -----
> From: Goh, Winston <winston.goh@sg.unisys.com>
> To: 'Li Chaoyong' <hughcyli@holybridge.com.cn>; <ccielab@groupstudy.com>
> Sent: Wednesday, April 19, 2000 9:00 AM
> Subject: RE: How to filter NETBIOS in DLSW PEER
>
>
> > Hi,
> > For your second question, create a access-list 600-699 permit/deny the
cable
> > range of the appletalk network. Apply the access-list through appletalk
> > distribution-list out under the interface coomand. Remember to permit
> > other-access at the end of your acl. i hope this help.cheers
> > winston
> >
> > -----Original Message-----
> > From: Li Chaoyong [mailto:hughcyli@holybridge.com.cn]
> > Sent: Saturday, April 15, 2000 4:15 PM
> > To: ccielab@groupstudy.com
> > Subject: How to filter NETBIOS in DLSW PEER
> >
> >
> > I want to know how to configure DLSW peers to allow NETBIOS only.
> >
> > Use lsap-output-list ?
> >
> > Please help me.
> >
> > -----------------------
> >
> > Another Question
> >
> > In this condition
> >
> > R1----------R2
> >
> > R1 and R2 is runing APPLETALK EIGRP. How to filter EIGRP APPLETALK
ROUTE?
> >
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:23:15 GMT-3