From: dhbrown@xxxxxxxxxxxx
Date: Fri Mar 17 2000 - 19:14:48 GMT-3
Sure works on my setup... Thanks Jeff!
David
jbazar <jbazar@ccci.com> wrote:
> Ronald
Do a debug ip packet. You will notice that your encapsulation will fail for up
dates being sent out s0. That is because bridging is being done on this interf
ace for IP, and packets are going to your BVI to route packets. When you use st
andard bridging without IRB, bridging is only done on non-routable protocols.
IRB will bridge all protocols as soon as you turn it on (including IP).
If you want to continue to use the BVI, you must use that one address for the w
hole bridge group. In your case, you have 3 IP addresses on the same LAN. If
you would rather use the IP addresses on the physical interfaces, type "no brid
ge 1 bridge IP". This will disable the bridging of IP in bridge group 1. You
will not need the BVI in this case.
try it out
jeff
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:23:05 GMT-3