From: ejobson (ejobson@xxxxxxxxxxx)
Date: Wed Mar 15 2000 - 18:54:07 GMT-3
When the 'show dialer map' command is entered and a dynamic setting is shown
and will therefore not let you enter a manual dialer map command, what
causes this dynamic one to appear in the first place?
I seemed to put it down to RIP running and cleared it by setting a couple of
interfaces up as passive and doing a 'clear ip route *'
Can anyone confirm, thanks.
Eddie Jobson
Internetwork Solutions Engineer
Nevolutions UK Ltd. a division of
Total Network Solutions Inc.
7th Floor, Tower 42
The International Finance Centre
25 Old Broad Street
London
EC2N 1HN
Office +44 (0)171 877 1992
Fax +44 (0)171 877 1059
Mobile +44 (0)7867 505635
Email ejobson@tns-inc.com
Website http://www.tns-inc.com
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:23:05 GMT-3