From: ejobson (ejobson@xxxxxxxxxxx)
Date: Mon Mar 06 2000 - 14:31:39 GMT-3
In the lab cisco seem to indicate that 2500, 4000 and cat 5000/5500 are the
standard pieces of kit used. Are the ATM lab questions only related to these
bits of kit or is it necessary to get access to an ls1010 before attempting
the lab.
Eddie Jobson (UK)
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Rob Ehlers
Sent: Friday, March 03, 2000 2:34 AM
To: CCIELAB
Subject: Re: LANE and ATM
Well, you can issue the commands on the card, but there isn't much way to
test it, unless you have some kind of ATM switch inbetween. An old
lightstream 100 would do, if you can find out. You can put a loopback on
the ATM interface to get it UP,UP... I guess you could run some debug
commands to see if it performing correctly after that.
On Thu, 2 Mar 2000 josh@mstates.com wrote:
> Is it possible to configure LANE without a LS1010 in the configuration or
> must you have a LS1010 to complete?
>
> Josh
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:23:04 GMT-3