From: Muralidhar Devarasetty (dhar_murali@xxxxxxxxxxx)
Date: Mon Mar 06 2000 - 12:25:08 GMT-3
Try to Ping to multicast address.
Findout multicast route using "sh ip mroute" in all routers using multicast.
In switch "sh ip multicast group" and check the multicast mac address for
the multicast ip address.
Hope this helps U.
Murali
----Original Message Follows----
From: Khurram Khani <ajmal@emirates.net.ae>
Reply-To: Khurram Khani <ajmal@emirates.net.ae>
To: Ben_J_Durand@tivoli.com, ccielab@groupstudy.com
Subject: Multicasting - !!
Date: Sun, 05 Mar 2000 20:07:45 -0800
Hi.
I have just gone through CCO Multicast Doc
They have not given any good and descriptive
example in it
Now I have
eth 0 R1se0------se0 R2 se1-----se0 R3 eth0
ip multicasting
All Se0s in ip pim dense mode,
In eth0 I just joined a group 224.10.10.10
Now what I should to do to make sure my config
is working.
Can any give me brief CHECKLIST like
1. do this
2. do this
To make sure that my Dense and Sparse mode are
working fine
Thanks
KHURRAM KHANI.
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:23:04 GMT-3