From: Dave Gahm (gahm@xxxxxxx)
Date: Mon Feb 28 2000 - 03:57:29 GMT-3
David,
On the AGS+ there are dip switch settings which determine whether a serial
port is a DTE or a DCE. Check the switch setting or try a DCE cable.
Dave
-----Original Message-----
From: David H. Brown <DHBrown@pipeline.com>
To: ccielab@groupstudy.com <ccielab@groupstudy.com>
Date: Sunday, February 27, 2000 8:19 PM
Subject: AGS+ to 2500 X-Over
>Hi all!
>
>I hope this is an easy one, but it's driving me nuts. I have the
following:
>
>2513 Serial 1 Serial 0 AGS+
>(R3) <--[DCE] crossover cable [DTE]--> (R4)
>
>During the AGS+ bootup, I get an Up Up status briefly on R3, then once R4
>finally boots both sides stay Down Down. I have tried multiple cables (I
>only have 2, got them from PacificCable.com) using Frame Relay, HDLC and
PPP
>encapsulations. Excerpt from configs (HDLC encap):
>
>R3 (DCE) IOS version 11.3(11a)
>!
>interface Serial1
>ip address 192.168.254.1 255.255.255.0
>clock rate 64000
>dce-terminal-timing-enable
>!
>
>R4 (DTE) IOS version 11.0(22)
>!
>interface Serial0
>ip address 192.168.254.2 255.255.255.0
>!
>
>This works fine connecting two 2500's (with 60-60 pin cable) up to clock
>rate 4000000. Does it have something to do with the differing versions of
>IOS? Any ideas?? Thanks!
>
>David Brown
>(RTP Lab 3/23/00)
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:22:54 GMT-3