From: jbazar (jbazar@xxxxxxxx)
Date: Sat Feb 26 2000 - 03:06:48 GMT-3
Since you are not using ilmi to register nsap address with the switch, you
must add static routes to the switch.
add the following command to the switch for each network
atm route (network) (atm-interface)
Example
1.nsap address of router attached to lightstream interface atm4/0/0
11.111111111111111111111111.111111111111.00
2.global command added to lightstream
atm route 11.1111 atm 4/0/0
Hope this helps
jeff
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
zhencai
Sent: Friday, February 25, 2000 11:09 PM
To: ccielab@groupstudy.com
Subject: ATM SVC
Importance: High
Hi,
I'm trying to configure ATM SVC without ilmi, I use the example from CCO:
http://www.cisco.com/warp/public/121/13.html
but for some reason, two routers can't ping each other. If I change to SVC
with ilmi and use esi address, it works. Anyone had the same problem before?
Here is how I get NASP prefix: enable ilmi, show atm ilmi-status,
copy&paste, disable ilmi. Is this the problem?
Thanks a lot.
Zhen Cai
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:22:54 GMT-3